Priority switch satellite dish 950-2400 MHz

Priority switch for connecting two satellite receivers to a cable from LNB. When the priority receiver on the "Master" connection is turned off, the priority switch chooses to send the signal to the "Slave" connection.

The priority switch makes it possible to connect two receivers to the same dish. The A input has the first priority (master) and controls the LNB device until the receiver on the A input turns off. When the receiver on the A input is switched off, the B input goes from slave to master, thus sending the signal from LNB to the receiver on the B input. Smart if you use two receivers in your setup or need to switch antenna input via DC voltage, 22 KHz or DiSEqC.