

Leave us a message
Get 3% off on your next purchase
Offer expires in
Click the button below to unlock the deal and reveal a discount code to use at checkout.
Electronic alcohol tester with three levels for indication of blood alcohol level. It works on the principle of a breath test. Ideal for an indicative alcohol screening for drivers, for driving schools or for checking employees, etc. alcohol tests of this type can only be used as indicative reference alkohol tests.
Electronic alcohol tester with three levels for indication of blood alcohol level. It works on the principle of a breath test. Ideal for an indicative alcohol screening for drivers, for driving schools or for checking employees, etc. alcohol tests of this type can only be used as indicative reference alkohol tests.
No additional refills are required for the device to work, so you don't need to buy additional tubes or capsules etc. Very simple operation.
- the unit's measuring range, indication:
0.0 - 0.2? BAC - green LED
0.2? - 0.5? - yellow LED
>0.5? - yellow+red LED
Flashlight with red LED diode
Power supply: 2xAAA batteries
alcohol tester - simple operation:
1. Press and hold the button (POWER) on the front during the entire measurement. An orange and a red light will illuminate and the heating of the sensor will be activated if necessary. It can take up to 15 seconds to warm up, even longer when you use it for the first time after a long time. When the green indicator lights up, the device is ready.
2. From the moment the green indicator lights up, the device is ready to measure within 3-5 seconds. Blow from a distance of approx. 5 cm from the mouth for approx. 3-5 seconds into the grid (6) of the device. Try to keep the specified distance between your mouth and the device and exhale evenly.
3. The device performs the analysis and displays the measurement result.
4. If a value higher than 0.05% (0.5%) is detected, the red and yellow LED indicators will light up.
5. If a value greater than 0.02% (0.2%) but less than 0.05% (0.5%) is detected, the yellow LED indicator lights up.
6. If a value lower than 0.02% (0.2%) is detected, the green LED indicator will remain on.
7. Release the button (POWER), the device turns off.
8. For another test, turn the device back on using the button on the front of the device and repeat steps 1-7 above. If the device does not detect alcohol when the test is repeated shortly after, wait approx. 10-20 minutes and perform the test again.
9. To get the most accurate result (the breath measurement of alcohol in the blood is always only indicative) repeat the measurement 2-3 times.
Using the flashlight The flashlight's LED is turned on and off with the slide switch. Do not switch on the lamp before or during the measurement of the amount of alcohol.
Before using the alcohol tester, you must not have drunk alcohol or smoked for 20 minutes. Do not use the alcohol tester immediately after drinking alcohol, the sensor may be destroyed and the warranty will be lost! Rinse your mouth with water before taking the measurement. Remember that the breath measurement of alcohol in the blood is always indicative only.
You might also like
Electronic alcohol tester with three levels for indication of blood alcohol level. It works on the principle of a breath test. Ideal for an indicative alcohol screening for drivers, for driving schools or for checking employees, etc. alcohol tests of this type can only be used as indicative reference alkohol tests.